| auszookers.com https://auszookers.com/forum/ |
|
| Blueslip/engineers nsw. https://auszookers.com/forum/viewtopic.php?f=5&t=42836 |
Page 1 of 1 |
| Author: | jmd-247 [ Fri Sep 06, 2013 4:29 pm ] |
| Post subject: | Blueslip/engineers nsw. |
I have purchased a new project zook. A lwb Holden drover ute. Narrow track 1.3 ltr. It requires a blue slip in nsw but have few questions for all the smarts people. I intent on a g16b with 4 speed Vitara auto. Fresh suspension all around Diffs etc etc I am more worried about being able to engineer the engine/trans setup ready for Blueslip. I am familiar with what has to be done in the build but not the legalities. Has anybody gone through this recently and Hve any pointers.? I am speaking with an engineer next week but wanted other experiences to relate to. Cheers. All help appreciated. Josh. |
|
| Author: | DarkHorse [ Fri Sep 06, 2013 11:52 pm ] |
| Post subject: | Re: Blueslip/engineers nsw. |
You've already done the best first thing - talk to an engineer. So much of the legalities are subject to the certifying engineer and their interpretation. Depending on the details of what you are planning you shouldn't have a problem with G16B and auto. |
|
| Author: | rob45x [ Sat Sep 07, 2013 7:54 am ] |
| Post subject: | Re: Blueslip/engineers nsw. |
Freshen it up for blueslip Get rego Then do conversion after ! |
|
| Author: | got_bar_work [ Sat Sep 07, 2013 8:40 am ] |
| Post subject: | Re: Blueslip/engineers nsw. |
Y then u need 2 blueslips |
|
| Author: | rob45x [ Sat Sep 07, 2013 9:35 am ] |
| Post subject: | Re: Blueslip/engineers nsw. |
if you do the conversion neat enough i dont think any coppa will pick it up if u get pulled over |
|
| Author: | Santos [ Sat Sep 07, 2013 2:39 pm ] |
| Post subject: | Re: Blueslip/engineers nsw. |
do you need a blueslip for an engine conversion in a registered vehicle in nsw? |
|
| Author: | DarkHorse [ Sat Sep 07, 2013 3:13 pm ] |
| Post subject: | Re: Blueslip/engineers nsw. |
Hell yes. Unless it's the same model engine going in (therefore not a conversion) it is classified as a significant modification and therefore requires engineering. To get the engineers cert processed you need to get a blueslip done. It's usually only about $150 so not ridiculous, but better if you can avoid paying it twice. |
|
| Author: | jmd-247 [ Sat Sep 07, 2013 7:56 pm ] |
| Post subject: | Re: Blueslip/engineers nsw. |
Yeah dark horse that's the way I see it. At the end of it all , it's going to be huge rubber, so I want everything else hunky dory. G16b and auto all listed, plus the brakes etc so I will see what the engineer will say, was more looking for someone with an engineered auto g16b and what things were picked on. Cheers boys. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|