| auszookers.com https://auszookers.com/forum/ |
|
| anyone in melbourne have access to a shop press? https://auszookers.com/forum/viewtopic.php?f=5&t=43079 |
Page 1 of 1 |
| Author: | oohsam [ Sun Sep 22, 2013 12:02 pm ] |
| Post subject: | anyone in melbourne have access to a shop press? |
Hey guys Am pressing out my front bearings. Borrowed a mates 6tonne press but it's not strong enough to press out the bearing race. Anyone have access to a bigger press that could help me out today. Otherwise I'll have to find a shop tomorrow that's willing to do it for me. Thought the 6 tonne would do the trick! Cheers. |
|
| Author: | shandy92 [ Sun Sep 22, 2013 12:48 pm ] |
| Post subject: | Re: anyone in melbourne have access to a shop press? |
you did remove the cer-clip thats under the seals right? |
|
| Author: | oohsam [ Sun Sep 22, 2013 12:51 pm ] |
| Post subject: | Re: anyone in melbourne have access to a shop press? |
Yeah all removed |
|
| Author: | want33s [ Sun Sep 22, 2013 6:30 pm ] |
| Post subject: | Re: anyone in melbourne have access to a shop press? |
If a 6 tonne press won't do it you have missed a circlip or are doing something else wrong. |
|
| Author: | oohsam [ Mon Sep 23, 2013 8:57 am ] |
| Post subject: | Re: anyone in melbourne have access to a shop press? |
Nah circlips were def out, Cant see what I could be doing wrong, line it up, jack the press till it goes bang! I took em to the shop this morning, 20tonne press wouldn't get them out. We had to heat it up with a oxy then it popped out... Was a royal prick...The guys at the shop said it happens from time to time. All done now! |
|
| Author: | got_bar_work [ Tue Sep 24, 2013 9:36 am ] |
| Post subject: | Re: anyone in melbourne have access to a shop press? |
when i fist did mine we did it with a 30t and it went out with a mighty BANG! every other time has been fine they were prob originals |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|