auszookers.com
https://auszookers.com/forum/

Suzuki sierra gearbox gods please help
https://auszookers.com/forum/viewtopic.php?f=5&t=43100		 Page 1 of 1
Author:  Llewellyn92 [ Mon Sep 23, 2013 10:06 am ]
Post subject:  Suzuki sierra gearbox gods please help
Hey guys, I've got a problem for the gearbox gods that i was hoping to get a little help with. I'm currently rebuilding a sierra gearbox for a mate but I've run into a little bit of a problem
Image
I cant get this sleeve (flathead screwdriver is on it) off to pull apart the rest of the gear set. i cant just press from the bearing because there will be a little ball which sits in a little recess between the bearing and the sleeve which you can see in this photo i've found
Image
and it would be very difficult to press from the spacer between the bearing and the sleeve because of the chamfered edge and the fact that there is very little room to pry from.
Any suggestions?
Cheers
Author:  Matthew [ Mon Sep 23, 2013 11:28 am ]
Post subject:  Re: Suzuki sierra gearbox gods please help
Have you had a look at the FSM?

It says to press the washer and bush off first, then the bearing.
Author:  31zook [ Mon Sep 23, 2013 12:13 pm ]
Post subject:  Re: Suzuki sierra gearbox gods please help
Yes you can, the ball bearing stops the washer from turning. Just press the washer (not bearing) off and the ball bearing will drop out.
Author:  Llewellyn92 [ Mon Sep 23, 2013 4:36 pm ]
Post subject:  Re: Suzuki sierra gearbox gods please help
Thanks guys ill figure out a way to press it off then. Where have you guys got your FSM from? each time i go to look for one i cant find any for free?
Author:  Matthew [ Mon Sep 23, 2013 4:42 pm ]
Post subject:  Re: Suzuki sierra gearbox gods please help
http://suzukiinfo.com/
Author:  mrw82 [ Mon Sep 23, 2013 6:47 pm ]
Post subject:  Re: Suzuki sierra gearbox gods please help
use a bearing separator between the bearing and washer

Image
Author:  31zook [ Mon Sep 23, 2013 9:32 pm ]
Post subject:  Re: Suzuki sierra gearbox gods please help
X2 for the above two posts.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/