| auszookers.com https://auszookers.com/forum/ |
|
| Sierra, vitara alloy pulleys into jimny https://auszookers.com/forum/viewtopic.php?f=5&t=43275 |
Page 1 of 1 |
| Author: | cal213 [ Fri Oct 04, 2013 9:37 am ] |
| Post subject: | Sierra, vitara alloy pulleys into jimny |
Anyone got measurements or quiet certain the alloy pulleys from low range offroad suit the jimny? Ones im looking at are: 1.6 twin serpentine crank keu-dscpk Tc style power steering pump sst-tcp And also the water pump pulley seu-swpp , says 8v only. Dot see what that could effect in regards to a pulley |
|
| Author: | 303zuke [ Fri Oct 04, 2013 6:51 pm ] |
| Post subject: | Re: Sierra, vitara alloy pulleys into jimny |
Double check the mounting bolts for your crank pulley. SJ50/SJ70 Sierra with the G13A or G13BA had 4 mounting bolts to hold the pulley on. GTi Swift with G13B, and Vitara with G61A had 5 mounting bolts. I know the Jimny uses a wider crank timing pulley (25mm) compared to the Sierra (19mm), and the Jimny also has a reluctor ring on it for the Crank Angle Sensor, so the Jimny belt pulley might have a different bolt pattern and possibly a different offset. |
|
| Author: | cal213 [ Fri Oct 04, 2013 8:27 pm ] |
| Post subject: | Re: Sierra, vitara alloy pulleys into jimny |
Aaah good hints, i know the jimny has a 5 bolt and a pin locator instead of a keyway. The vitara or baleno g16a i put in used a 5 bolt and keyway. Low range didnt really help me much in regards to dimensions of their pulleys, maybe in fear of me remanufacturing them. I dont know... :/ They list one for the vitara 1.6 with pin and 5 bolt for the crank. Sadly i didt get a pulley with my donor motor |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|