auszookers.com
https://auszookers.com/forum/

Petroworks 1.6 kit - Extractors??
https://auszookers.com/forum/viewtopic.php?f=5&t=43610		 Page 1 of 1
Author:  matfan [ Mon Oct 28, 2013 9:24 am ]
Post subject:  Petroworks 1.6 kit - Extractors??
Hi All,

Does anyone know what brand of extractors fit a sierra with the 1.6 petroworks kit installed? I currently have Lukey extractors but they've been bashed to fit it and they're pretty rusty anyway. Any help would be appreciated.

Cheers
Matt
Author:  Chop [ Mon Oct 28, 2013 10:14 am ]
Post subject:  Re: Petroworks 1.6 kit - Extractors??
Do the lukey hit the chassis? Mine did when I put the g16A in mine, so I got them modified and that didn't cost much.
Author:  matfan [ Mon Oct 28, 2013 11:09 am ]
Post subject:  Re: Petroworks 1.6 kit - Extractors??
Not sure, the engine isn't in the car yet. There is a bashed-in spot just below the lukey badge that the previous owner must have done to make it fit. Like I said, it's rusty anyway so I think it's time for a new set. I was looking at the Doug Thorley tri-y extractors but I'd love to know if a set exists that doesn't require modification.
Author:  atari4x4 [ Mon Oct 28, 2013 5:46 pm ]
Post subject:  Re: Petroworks 1.6 kit - Extractors??
MPH do a header to suit the 1.6 into a Sierra, NFI if it works with the petroworks kit though... plenty of info on here about MPH headers.
Author:  matfan [ Tue Oct 29, 2013 2:38 pm ]
Post subject:  Re: Petroworks 1.6 kit - Extractors??
Yeah the petroworks kit has the engine sitting a hell of a lot lower in between the rails than any of the other kits. I've spoken to Petroworks and they tell me that in the states the thorley 716y headers work with the US delivered Samurai with the 16v conversion so I'll get the engine in and take some measurements and I'll report back when I find the solution.
Cheers for the help guys.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/