| auszookers.com https://auszookers.com/forum/ |
|
| Control Arm Bushes Sierra https://auszookers.com/forum/viewtopic.php?f=5&t=43682 |
Page 1 of 1 |
| Author: | JonnoR [ Fri Nov 01, 2013 12:22 pm ] |
| Post subject: | Control Arm Bushes Sierra |
Hi, the bushes in my rear control arm have had it so need to get them replaced. I was hoping to do this myself, just wanted to check a couple of things. It's for a Coil Sierra. 1. Can I get some bushes that I can put in without having to press them in? 2. If so can anyone recommend a decent set for the rear? 3. How hard/easy is it to get the old bushes out of the control arms? 4. Is it 3 bushes on each arm that I need to replace? Cheers. |
|
| Author: | ellis [ Fri Nov 01, 2013 3:06 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
Im pretty sure they need to be pressed in and out and yep 3 per arm |
|
| Author: | atari4x4 [ Fri Nov 01, 2013 3:12 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
buy genuine/rubber bushes or 6 months down the track you'll be posting about the poly bushes tearing the control arm mounts off the diff housing. |
|
| Author: | JonnoR [ Fri Nov 01, 2013 3:24 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
Ok guys, thanks for the help. Yeah I figured I would need a press to do the job, which I don't have. Atari, where is the best place to get them from, do you know? |
|
| Author: | atari4x4 [ Fri Nov 01, 2013 3:27 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
NFI i don't do sierra's, let alone coilys.  The part numbers for genuine rubber ones: Bush where arm attaches to diff is SZ4628281A30 and bush where arm attaches to the chassis is SZ4621365D01 teh sirch: viewtopic.php?f=5&t=8983&p=126107&hilit=coily+bush+genuine#p126107 |
|
| Author: | JonnoR [ Fri Nov 01, 2013 3:34 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
atari4x4 wrote: NFI i don't do sierra's, let alone coilys. The part numbers for genuine rubber ones: Bush where arm attaches to diff is SZ4628281A30 and bush where arm attaches to the chassis is SZ4621365D01 teh sirch: http://www.auszookers.com/forum/viewtop ... ne#p126107 Cheers, Appreciate it. |
|
| Author: | coily96 [ Sat Nov 02, 2013 9:39 pm ] |
| Post subject: | Re: Control Arm Bushes Sierra |
If you want to save some money you can push out the broken rubber and crush tube then hacksaw the outer case in two spots and knock them out. Then the shop only has to push the new ones in. You can get some rubber ones on ebay through 4wd products. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|