Has any one came across this problem were g16b hits the brake hard lines coming out of the brake cylinder. Running a 2 body lift. Body still has to go towards passenger side 10mm.
| auszookers.com https://auszookers.com/forum/ |
|
| problem fitting g16b https://auszookers.com/forum/viewtopic.php?f=5&t=43910 |
Page 1 of 1 |
| Author: | zooky08 [ Fri Nov 15, 2013 4:54 pm ] |
| Post subject: | problem fitting g16b |
Has any one came across this problem were g16b hits the brake hard lines coming out of the brake cylinder. Running a 2 body lift. Body still has to go towards passenger side 10mm.
|
|
| Author: | want33s [ Fri Nov 15, 2013 5:02 pm ] |
| Post subject: | Re: problem fitting g16b |
What engine mounts are you using? Commonwhore? |
|
| Author: | zooky08 [ Fri Nov 15, 2013 5:09 pm ] |
| Post subject: | Re: problem fitting g16b |
Looks like stock on ps and benT on ds. Engine was pulled from another sierra |
|
| Author: | stockman [ Fri Nov 15, 2013 5:55 pm ] |
| Post subject: | Re: problem fitting g16b |
I had to adjust the hardline when doing my g13bb conversion, but don't recall having to do it with my Baleno g16b conversion (slightly taller motor). |
|
| Author: | Rossco [ Fri Nov 15, 2013 6:48 pm ] |
| Post subject: | Re: problem fitting g16b |
I have the same setup and mine doesn't hit. There is some trickery going on somewhere, I'll check mine out in the morning. |
|
| Author: | azzas15 [ Sat Nov 16, 2013 8:10 am ] |
| Post subject: | Re: problem fitting g16b |
I have plenty of space on mine I'll check again when I get home |
|
| Author: | BenT [ Sat Nov 16, 2013 11:03 am ] |
| Post subject: | Re: problem fitting g16b |
Check that the cast engine mount brackets that bolt to the block are from the 1300. The 1600 ones are a different height and might be causing the engine to lean over. Ben |
|
| Author: | azzas15 [ Sun Nov 17, 2013 3:27 pm ] |
| Post subject: | Re: problem fitting g16b |
 Here is a pic of mine not sure why yours is so close |
|
| Author: | zooky08 [ Sun Nov 17, 2013 4:10 pm ] |
| Post subject: | Re: problem fitting g16b |
Yours is from a baleno right? My g16b is from a vitara. Might be different. You running body lift at all? |
|
| Author: | azzas15 [ Mon Nov 18, 2013 8:26 am ] |
| Post subject: | Re: problem fitting g16b |
Yes my G16b is from a Baleno |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|