auszookers.com
https://auszookers.com/forum/

Cutting my roktoy ring
https://auszookers.com/forum/viewtopic.php?f=5&t=44059		 Page 1 of 1
Author:  Asps91 [ Mon Nov 25, 2013 6:00 pm ]
Post subject:  Cutting my roktoy ring
Hey guys, i bought a t-case with 6.5.1 gears fitted to it. It came with a rocktoy ring already fabbed up ready to fit. I have just test fit it and the roktoy hits the transmition tunnel, i have taken some measurements and believe with a bit of massaging ;) and cutting into the roktoy it will fit, I cant run a body lift as im getting the car engineered and its already sprung over. The rocktoy ring is 6mm thick. I have attached a picture of what i propose to cut, do you guys think this is too much and that it will effect integrity of the ring.
Author:  Red89 [ Mon Nov 25, 2013 7:16 pm ]
Post subject:  Re: Cutting my roktoy ring
I have cut mine worse then that and havent had any dramas, but I do have a custom cradle.
Author:  Asps91 [ Mon Nov 25, 2013 9:54 pm ]
Post subject:  Re: Cutting my roktoy ring
Yea, didnt think there would be any dramas. Even with this cut of there is still a chance it won't fit, but I hope it does!
Author:  mrw82 [ Tue Nov 26, 2013 2:32 am ]
Post subject:  Re: Cutting my roktoy ring
I had to trim around the input shaft/top of the ring on my zook as aswell as the point you have marked.
Author:  just_cruizin [ Tue Nov 26, 2013 5:26 am ]
Post subject:  Re: Cutting my roktoy ring
You will also need some on the drivers side
Author:  Asps91 [ Tue Nov 26, 2013 3:41 pm ]
Post subject:  Re: Cutting my roktoy ring
Yea, ill guess ill keep fitting ,marking and grinding till I squeeze it in.
Author:  Red89 [ Tue Nov 26, 2013 5:30 pm ]
Post subject:  Re: Cutting my roktoy ring
mrw82 wrote:
I had to trim around the input shaft/top of the ring on my zook as aswell as the point you have marked.

Thats the other place mine is cut too.
Author:  Daves4wd [ Tue Nov 26, 2013 7:59 pm ]
Post subject:  Re: Cutting my roktoy ring
You'll need to cut abouts all to top off to clear.... I did it in mine and still going strong but still hits te floor... If you got the time and skill cut the floor and make a bulge in it to clear the ring
Author:  Asps91 [ Fri Nov 29, 2013 12:52 pm ]
Post subject:  Re: Cutting my roktoy ring
Almost in! Moulded the tunnel a bit with some brute force and a hammer. And a little more trimming of the ring and she will fit. I guess even with 2/3rds of the thickness of the ring removed from the top will still be a lot stronger than the standard mounts.
Author:  just_cruizin [ Fri Nov 29, 2013 7:01 pm ]
Post subject:  Re: Cutting my roktoy ring
It'll self clear after a couple of runs
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/