| auszookers.com https://auszookers.com/forum/ |
|
| G13bb jimny input shaft https://auszookers.com/forum/viewtopic.php?f=5&t=44613 |
Page 1 of 1 |
| Author: | cal213 [ Fri Jan 10, 2014 8:27 am ] |
| Post subject: | G13bb jimny input shaft |
Where can i get a replacement input for the g13bb gearbox. Im going to assume the only place is suzuki or a custom machined one. Where the spigot bearing sits on the tip has worn down a groove |
|
| Author: | Gwagensteve [ Fri Jan 10, 2014 8:33 am ] |
| Post subject: | Re: G13bb jimny input shaft |
Get it sleeved or welded? Otherwise you'll be looking for a whole second hand gearbox. Steve. |
|
| Author: | cal213 [ Fri Jan 10, 2014 11:22 am ] |
| Post subject: | Re: G13bb jimny input shaft |
That was the second idea, weld er up and machine it down at work. I have two gearboxes and rebuilding one now, i cant remember if my other box was the same in regards to the input. Im pretty sure it was. Ill get a pic |
|
| Author: | cal213 [ Fri Jan 10, 2014 4:13 pm ] |
| Post subject: | Re: G13bb jimny input shaft |
is this how it should look? i think the one in the car now looks the same after doing the clutch. it looks like its suppose to be, but after seeing an m13a one, i feel this could be wrong |
|
| Author: | Gwagensteve [ Fri Jan 10, 2014 5:25 pm ] |
| Post subject: | Re: G13bb jimny input shaft |
I vote that's how it's supposed to look . The spigot bearing will ride on the end just fine. Steve. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|