| auszookers.com https://auszookers.com/forum/ |
|
| Coil wiring on jimny https://auszookers.com/forum/viewtopic.php?f=5&t=44968 |
Page 1 of 1 |
| Author: | Bazooker [ Wed Feb 05, 2014 5:32 pm ] |
| Post subject: | Coil wiring on jimny |
The coils on the Jimny I have, 98 G13b, are aftermarket. I have had a few issues but because the current ones are not OME the loom was cut to accommodate. The original three pin plugs are gone so I have to manufacture new ones. Now I know that one wire is the signal br/blue, one is earth and one is continuous power. What I don't know is where these wires go into the coil.. Now I know this is a little hard to explain and harder because of my inability to post a picture. Holding the coils verticle you can see three horizontal plugs. Left middle and right. Now if one of you whizz kids can tell me which is which I can go from there. Help is appreciated as always. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|