| auszookers.com https://auszookers.com/forum/ |
|
| Ignition Wiring https://auszookers.com/forum/viewtopic.php?f=5&t=45185 |
Page 1 of 1 |
| Author: | rwt65 [ Fri Feb 21, 2014 11:23 am ] |
| Post subject: | Ignition Wiring |
Am wiring a Killa Kustom Loom into my Sierra Ignition Key switch has four wires White White with Black stripe Black with White stripe Black with Yellow stripe Which wire is which? Battery Positive (White?) Ignition Positive (Black with White stripe?) Start Signal (Black with Yellow stripe?) White with black stripe? Any help appreciated 
|
|
| Author: | Reubs [ Fri Feb 21, 2014 12:32 pm ] |
| Post subject: | Re: Ignition Wiring |
If you can use a multimeter or rig up a test light you can easily determine which is which. |
|
| Author: | 31zook [ Fri Feb 21, 2014 11:11 pm ] |
| Post subject: | Re: Ignition Wiring |
Maybe ask killa? |
|
| Author: | losfer [ Mon Feb 24, 2014 6:35 pm ] |
| Post subject: | Re: Ignition Wiring |
white is constant power for memory backup of ecu . white with black strip not sure , shouldnt be needed for efi loom ...? black with white is ignition on power , usually run through the coil/meter part of original loom . black with yellow is starter signal both the memory backup and the ignition on powers should be fused , there should also be an extra wire , think its blue with a black stripe that should be ignition on power othas well .. all this is off the top of my head without looking at a diagram ... |
|
| Author: | whincup [ Tue Feb 25, 2014 10:49 pm ] |
| Post subject: | Re: Ignition Wiring |
according to the FSM, the wires at the ignition key barrel should be white/yellow (constant), blue (acc), black/blue (ign) and black/yellow (starter). |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|