auszookers.com
https://auszookers.com/forum/

aftermarket tacho wiring
https://auszookers.com/forum/viewtopic.php?f=5&t=4525		 Page 1 of 1
Author:  slysuz [ Tue Apr 07, 2009 2:01 am ]
Post subject:  aftermarket tacho wiring
hi guys i did serch but couldnt find anything i bought a aftermarket tacho off ebay and it came with no instructions on wiring it up so just wondering any pointers on how to wire it up its got.. two thick wires one red and black... then its got three smaller wires being red,black and green any help whould be helpful
Author:  chef [ Tue Apr 07, 2009 4:10 am ]
Post subject:  Re: aftermarket tacho wiring
red is power
black is ground
green is dizzy

i think
Author:  Mike [ Tue Apr 07, 2009 4:22 am ]
Post subject:  Re: aftermarket tacho wiring
and would the 2 smaller red and black wires be for the light in the gauge
Author:  Rockhopper [ Tue Apr 07, 2009 9:55 am ]
Post subject:  Re: aftermarket tacho wiring
chef wrote:
red is power
black is ground
green is dizzy

i think


I think so to but not entirely sure. The other two wires I suspect are for the light, but the best thing I could suggest is email the guys you bought it off and ask them.
Author:  morpheus [ Tue Apr 07, 2009 1:06 pm ]
Post subject:  Re: aftermarket tacho wiring
that red. black, green sounds right. but i think the green connects 2 the coil, maybe the + side of the coil? & make shure the switch on the back is set to 4 cylinders :-)
Author:  Rockhopper [ Tue Apr 07, 2009 1:56 pm ]
Post subject:  Re: aftermarket tacho wiring
morpheus wrote:
but i think the green connects 2 the coil, maybe the + side of the coil?


Signal pulse is from the negative side of the coil, so connect the green to the -
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/