| auszookers.com https://auszookers.com/forum/ |
|
| How much offset to get on GV https://auszookers.com/forum/viewtopic.php?f=5&t=45359 |
Page 1 of 1 |
| Author: | Sco-tie [ Tue Mar 04, 2014 10:22 pm ] |
| Post subject: | How much offset to get on GV |
I'm looking at some new rims and have the option of having any offset from -25 to 0 and am wondering how far out i should go and what would be plausible without being stupid? Planning on running 245/75 muds on them. 4.5in rear, 4in front with 3in bump stops. Was thinking around -18 maybe? and running flares of course. |
|
| Author: | Built4thrashing [ Wed Mar 05, 2014 3:29 pm ] |
| Post subject: | Re: How much offset to get on GV |
If the tyres are gonna be outside the wheel arch your going to loose a lot of up travel as tyres will hit the guard. Whats wrong with the stock wheel options? |
|
| Author: | Sco-tie [ Wed Mar 05, 2014 5:59 pm ] |
| Post subject: | Re: How much offset to get on GV |
Yes they will be out of the guard but not as much to limit travel. I know 245 with -13 clears fine, maybe thats as far as you can go. Stock wheels are 0 to no offset and alloy or steel. I'm just after some offset not fussed on what rims its actually on |
|
| Author: | Joe [ Wed Mar 05, 2014 10:07 pm ] |
| Post subject: | Re: How much offset to get on GV |
What sort of rims are you planing on getting? |
|
| Author: | Sco-tie [ Wed Mar 05, 2014 10:11 pm ] |
| Post subject: | Re: How much offset to get on GV |
Looking around for any that will fit the calipers. So far only ones i know that fit the gv for sure at Dick Cepek ones. Apparently a few of the allide rims fit as well |
|
| Author: | klutched [ Thu Mar 06, 2014 7:45 am ] |
| Post subject: | Re: How much offset to get on GV |
I believe stock offset is +5 on the GV rims. I'd say just go -13s because you know it'll fit. |
|
| Author: | fordem [ Thu Mar 06, 2014 9:46 am ] |
| Post subject: | Re: How much offset to get on GV |
klutched wrote: I believe stock offset is +5 on the GV rims. If I'm not mistaken that's what the OEM Enkei alloys on my GV have cast into them - and yes - I am too lazy to take one off to check. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|