| auszookers.com https://auszookers.com/forum/ |
|
| Sierra tailshaft/jackshaft lengths https://auszookers.com/forum/viewtopic.php?f=5&t=45518 |
Page 1 of 1 |
| Author: | JuniorJoel [ Wed Mar 19, 2014 7:23 am ] |
| Post subject: | Sierra tailshaft/jackshaft lengths |
Hey guys-- I am after the length (end to end) of the front shaft and intermediate shaft out of a wide track sierra. eg, the shaft from the gearbox to transfer case, and the shaft from the transfer to the front diff. Just having some difficulty putting my sierra transfer into my jimny and thinking i may have the wrong shafts. Any help much appreciated. Thanks, Joel |
|
| Author: | JuniorJoel [ Wed Mar 19, 2014 8:54 am ] |
| Post subject: | Re: Sierra Tail shaft lenghts |
Mine measure Gearbox to transfer- 360mm (end to end) Transfer to front diff- 680mm (end to end) They appear to be to short as the yoke is almost out and the spline is almost out aswell which is why I presume they can't be right. At full droop they would pretty much fall out. |
|
| Author: | JuniorJoel [ Wed Mar 19, 2014 1:43 pm ] |
| Post subject: | Re: Sierra Tail shaft lenghts |
I spoke to a wreckers and they said there's measured Gearbox to transfer- 402mm Transfer to front diff- 720 Does this sound more correct. I think that is more close to the correct measurements. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|