| auszookers.com https://auszookers.com/forum/ |
|
| 1997 v6 Ironman 2" lift for 1996 1.6 LWB https://auszookers.com/forum/viewtopic.php?f=5&t=45532 |
Page 1 of 1 |
| Author: | taszooker [ Thu Mar 20, 2014 11:31 am ] |
| Post subject: | 1997 v6 Ironman 2" lift for 1996 1.6 LWB |
Hey guys. Well as the title says I'm looking at a 2" suspension lift kit second hand that has come off a 1997 v6 LWB. I have a 1996 JX lwb 1.6 and was wondering if it would fit? I have read the Ironman setups run pretty stiff, so was worried that the v6 setup might be to stiff for me. Thoughts? Cheers. Matt |
|
| Author: | DarkHorse [ Fri Mar 21, 2014 8:29 pm ] |
| Post subject: | Re: 1997 v6 Ironman 2" lift for 1996 1.6 LWB |
Will fit, but as you say will probably be pretty jarring. Maybe call an Ironman dealer and compare part numbers? |
|
| Author: | taszooker [ Sat Mar 22, 2014 10:51 am ] |
| Post subject: | Re: 1997 v6 Ironman 2" lift for 1996 1.6 LWB |
Cheers DarkHorse. Will check out the part numbers. Only just starting the build after tidying the car up, but this was a great deal for a setup that has done very little KM's. |
|
| Author: | DarkHorse [ Sat Mar 22, 2014 11:31 am ] |
| Post subject: | Re: 1997 v6 Ironman 2" lift for 1996 1.6 LWB |
Go start yaself a build thread and keep us posted: viewforum.php?f=4 Have a read around - there are plenty of good 1.6 builds... plus a lot of the 2L stuff applies as well. Ask any questions you can't find answers to. Enjoy! |
|
| Author: | taszooker [ Sat Mar 22, 2014 2:51 pm ] |
| Post subject: | Re: 1997 v6 Ironman 2" lift for 1996 1.6 LWB |
I will once my new born is a bit older and I can spend some time and money. Not much happening at the moment other than some engine work (gaskets, timing belt etc). Cheers! |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|