| auszookers.com https://auszookers.com/forum/ |
|
| Sierra Wax Pellet https://auszookers.com/forum/viewtopic.php?f=5&t=45841 |
Page 1 of 1 |
| Author: | maxtest [ Sat Apr 12, 2014 4:47 pm ] |
| Post subject: | Sierra Wax Pellet |
My sierra is idling high about 1800rpm. I have been advised by a few people that it is the auto choke stuck on potentially caused by the wax pellet. What do I do about this? |
|
| Author: | Blkfxx [ Sat Apr 12, 2014 4:59 pm ] |
| Post subject: | Re: Sierra Wax Pellet |
Take the air hat off the top of the carby and start her up (cold), See if the choke flap drops away once it warms up a bit. |
|
| Author: | maxtest [ Sat Apr 12, 2014 5:02 pm ] |
| Post subject: | Re: Sierra Wax Pellet |
It doesnt and the two water hoses at the back of the carby dont get warm, so theres a blockage somewhere |
|
| Author: | droverdave [ Sat Apr 12, 2014 6:30 pm ] |
| Post subject: | Re: Sierra Wax Pellet |
The little widget that the two water lines go to, i pulled mine apart when i did my carby rebuild. it was completely blocked up with something thats for sure. I cleaned it all out, and i definitely have hot water flowing through those pipes, though it didnt seem to help with the high idle.. I just turned the idle down to ~1000rpm and it idles at this weather its hot or cold. |
|
| Author: | cairns27 [ Sun Apr 13, 2014 5:59 pm ] |
| Post subject: | Re: Sierra Wax Pellet |
You should be able to pull those hoses off the carby by hand and clean things out with a bit of wire. Worked for me once. bye |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|