| auszookers.com https://auszookers.com/forum/ |
|
| Slipping out of gear https://auszookers.com/forum/viewtopic.php?f=5&t=45969 |
Page 1 of 1 |
| Author: | oohsam [ Wed Apr 23, 2014 3:36 pm ] |
| Post subject: | Slipping out of gear |
Hey guys, Just have a generic question. My cousins vitara is slipping out of first under load. ie. pop it into first, as soon as you take off, it slips out of gear, into Neutral. If you hold it in place its, fine. all other gears are ok. I'm thinking its a gear linkage issue, this is a gearbox out, crack the gearbox open fix, right? Is it a DIY jobbie.. ? |
|
| Author: | tanshi [ Wed Apr 23, 2014 3:46 pm ] |
| Post subject: | Re: Slipping out of gear |
can you hold it in gear or does it force it out no matter what. broken gearbox mounts? rubber boot too tight and pulling it out. check all the simple things first. the linkages are all internal so if its caused by that then yes you will need to pull the box and no its not really a diy |
|
| Author: | Jezza86 [ Wed Apr 23, 2014 3:51 pm ] |
| Post subject: | Re: Slipping out of gear |
Spring loaded ball hold the selector in place in these? |
|
| Author: | oohsam [ Wed Apr 23, 2014 3:59 pm ] |
| Post subject: | Re: Slipping out of gear |
Yeah, if i hold it in place, its takes off fine, and i can let go, and it stays in gear. Its only on the inital load when taking off. I'll check the easy stuff. I've read that it MAY be a gearbox mount...would thikn it would do it for all gears if this was the case..not sure. |
|
| Author: | tanshi [ Wed Apr 23, 2014 4:01 pm ] |
| Post subject: | Re: Slipping out of gear |
not nessessarily, first is right in the corner so its pulling in two directions. |
|
| Author: | oohsam [ Wed Apr 23, 2014 4:03 pm ] |
| Post subject: | Re: Slipping out of gear |
You make a good point tanshi. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|