| auszookers.com https://auszookers.com/forum/ |
|
| GV / Vitara CV shaft differences https://auszookers.com/forum/viewtopic.php?f=5&t=46074 |
Page 1 of 1 |
| Author: | Built4thrashing [ Fri May 02, 2014 4:35 pm ] |
| Post subject: | GV / Vitara CV shaft differences |
Ok so I'm trying to fix up the front suspension a bit in the GV and need to sort the issue with the front drivers inner CV pulling out of the side gear slightly on full flex I know the SE Vitara shafts are smaller and have a different spline count on the diff. (22 spline) And I know the SV420/620 have a 26 spline inner and are slightly longer in the spline/bearing shoulder. As I have a lockright fitted to the front I need this longer inner cv to get it to lock into the diff side gear. What im trying to find out is will a SV Vitara CV shaft be a straight swap for the GV with the lockright? Is the length from oil seal to oil seal on the inner and outer cvs the same? Can someone take and post a photo of a GV shaft besides a SV Vitara shaft and post it up. I can get new SV shafts for $135+GST new but want to make sure it will fit before ordering. Or does anyone near me have one I can borrow to see if it fits. B4T |
|
| Author: | klutched [ Fri May 02, 2014 6:23 pm ] |
| Post subject: | Re: GV / Vitara CV shaft differences |
If I remember correctly they are the same because the SV is wider than the SE. 90% Sure it will be a straight swap over. |
|
| Author: | Built4thrashing [ Fri May 02, 2014 6:32 pm ] |
| Post subject: | Re: GV / Vitara CV shaft differences |
Hope so....... will do some more digging before I spend the coin. |
|
| Author: | fordem [ Fri May 02, 2014 10:20 pm ] |
| Post subject: | Re: GV / Vitara CV shaft differences |
Someone (Gus I think) had a post with pictures of the various shafts side by side. |
|
| Author: | Built4thrashing [ Sat May 03, 2014 8:16 am ] |
| Post subject: | Re: GV / Vitara CV shaft differences |
ok... where I spent hours last night looking at CV stuff here and on US forums..... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|