auszookers.com
https://auszookers.com/forum/

Help with jimny parts identification
https://auszookers.com/forum/viewtopic.php?f=5&t=46151		 Page 1 of 1
Author:  suzukikid [ Thu May 08, 2014 10:28 am ]
Post subject:  Help with jimny parts identification
Hey all I have been offered these jimny parts and want to know exactly what they are....

The car they came out of was a project car and was on 33s back before I was 18 so at least 7 years ago!!! We're all running fine when they got ripped out but have been sitting all that time.... All openings have tape and everything over them!

This is obviously a transfer case.... Are they all the same?

Image

This is an auto box? Do all jimnys run the same auto? Is it possible to bolt this in my sierra?

Image

Also what would they be worth? Thanks in advance for any info!
Author:  JuniorJoel [ Thu May 08, 2014 10:50 am ]
Post subject:  Re: Help with jimny parts identifaction
Hey,

Jimny tansfers differ amoungst the years with there gearing. Both auto's and manuals are chain driven but the auto chain is alot thinner from what i have been told. The auto, im not to sure. Jimnys have a split gearbox and transfer with a small prop shaft between the 2 so my guess would be it is out of a vitara or something similar.
Author:  tanshi [ Thu May 08, 2014 10:54 am ]
Post subject:  Re: Help with jimny parts identifaction
that isnt a jimny auto, its a vitara gearbox. and it doesnt look like an auto either its a manual as it has holes for 2 gear sticks. if it is in good condition its worth maybe $200
just looks like a standard early jimny transfercase.
Author:  suzukikid [ Thu May 08, 2014 11:57 am ]
Post subject:  Re: Help with jimny parts identifaction
Ah really lucky I put it on here! Haha so vitara manual? Are they all the same?

And is there anyway to find out the year on the transfer?

Thanks heaps guys you are legends!!!
Author:  sideways [ Thu May 08, 2014 4:55 pm ]
Post subject:  Re: Help with jimny parts identifaction
Yeah, it's a vitara manual. The bellhousing patterns differ.

Pretty sure coz it's got a stick the transfer will be 1.32 high and 2.145 low. Could be a coily transfer also?
Author:  jimny_timmy [ Thu May 08, 2014 6:21 pm ]
Post subject:  Re: Help with jimny parts identifaction
JuniorJoel wrote:
Hey,

Jimny tansfers differ amoungst the years with there gearing. Both auto's and manuals are chain driven but the auto chain is alot thinner from what i have been told. The auto, im not to sure. Jimnys have a split gearbox and transfer with a small prop shaft between the 2 so my guess would be it is out of a vitara or something similar.

Jimny auto transfers do have a smaller chain, but only 5mm. Makes them uninterchangable as far as internals are concerned, but not unusable in this situation. The only differences would be year models as far as stick shift or push button (this one obviously being stick shift 99-05ish) and the ratios like you said :)
Author:  suzukikid [ Fri May 09, 2014 6:59 am ]
Post subject:  Re: Help with jimny parts identifaction
Thanks for the help guys! Keep the info coming if you can ill just put them up for sale but want to make sure I know exactly what they are before I do! Haha
Author:  zooky08 [ Sat May 10, 2014 11:37 am ]
Post subject:  Re: Help with jimny parts identifaction
Umm you can see the clutch lever on the side of the bell housing. Not sure we're the confusion came from.
Author:  suzukikid [ Sat May 10, 2014 2:24 pm ]
Post subject:  Re: Help with jimny parts identification
You can too! Haha I look like a dick! Haha I looked at it for 22 seconds I reckon! Haha
Author:  suzukikid [ Sun May 11, 2014 7:41 am ]
Post subject:  Re: Help with jimny parts identification
Sorry to dig this up again what year would the gearbox be? Just so I can right up a for sale add! Thanks guys
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/