| auszookers.com https://auszookers.com/forum/ |
|
| Can't get gearbox off https://auszookers.com/forum/viewtopic.php?f=5&t=46502 |
Page 1 of 1 |
| Author: | russty_2008 [ Mon Jun 02, 2014 7:02 pm ] |
| Post subject: | Can't get gearbox off |
Has anyone had trouble getting a 99 jimny gearbox off an engine (g13bb) I've checked 10 times that all the bolts are un done |
|
| Author: | Scrawny [ Mon Jun 02, 2014 7:04 pm ] |
| Post subject: | Re: Can't get gearbox off |
Sideways wiggle? Pry bar between gearbox and bellhousing? |
|
| Author: | MrRocky [ Mon Jun 02, 2014 7:08 pm ] |
| Post subject: | Re: Can't get gearbox off |
Take starter motor off |
|
| Author: | russty_2008 [ Mon Jun 02, 2014 7:16 pm ] |
| Post subject: | Re: Can't get gearbox off |
Yer starter is off have done a lot of prying and wriggling |
|
| Author: | Scrawny [ Mon Jun 02, 2014 7:17 pm ] |
| Post subject: | Re: Can't get gearbox off |
Is it loose around the bellhousing or still tight? |
|
| Author: | russty_2008 [ Mon Jun 02, 2014 7:21 pm ] |
| Post subject: | Re: Can't get gearbox off |
Yer it's moved 25 to 30 mill but won't go any further the engine and box is out of the car |
|
| Author: | zukenutter [ Mon Jun 02, 2014 7:22 pm ] |
| Post subject: | Re: Can't get gearbox off |
Even gap all around? |
|
| Author: | Scrawny [ Mon Jun 02, 2014 7:24 pm ] |
| Post subject: | Re: Can't get gearbox off |
Spigot bearing or spline must be grabbing. If you can get a pry bar on both sides then try giving it a bit of extra persuasion |
|
| Author: | zukenutter [ Mon Jun 02, 2014 7:24 pm ] |
| Post subject: | Re: Can't get gearbox off |
Are you taking the weight of the box so it can be pulled straight back? |
|
| Author: | russty_2008 [ Mon Jun 02, 2014 7:57 pm ] |
| Post subject: | Re: Can't get gearbox off |
Yer even gap all round I've sprayed a shitload of wd onto the spline and will let it sit and try tomorrow after work |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|