get some small diameter rubber hose & carefully split it straight down one edge the whole length or get some pinch weld from clark rubber or the wrecking yard.
pinch weld is the stuff you find on the welded seam of your door openings etc.
| auszookers.com https://auszookers.com/forum/ |
|
| Snorkel hole edging?!?! https://auszookers.com/forum/viewtopic.php?f=5&t=46825 |
Page 1 of 1 |
| Author: | Average joes [ Tue Jul 01, 2014 4:11 pm ] |
| Post subject: | Snorkel hole edging?!?! |
I'm building a snorkel out of stainless pipe and silicone joiners What can I use on the hole I cut in the body to stop the body rusting or cutting into the joiner |
|
| Author: | atari4x4 [ Tue Jul 01, 2014 4:19 pm ] |
| Post subject: | Re: Snorkel hole edging?!?! |
get some small diameter rubber hose & carefully split it straight down one edge the whole length or get some pinch weld from clark rubber or the wrecking yard. pinch weld is the stuff you find on the welded seam of your door openings etc.
|
|
| Author: | Average joes [ Tue Jul 01, 2014 4:46 pm ] |
| Post subject: | Re: Snorkel hole edging?!?! |
Cheers |
|
| Author: | atari4x4 [ Tue Jul 01, 2014 4:50 pm ] |
| Post subject: | Re: Snorkel hole edging?!?! |
too easy bud, oh and paint the cut edge to stop the rust.
|
|
| Author: | Goldnomad [ Thu Jul 03, 2014 10:47 am ] |
| Post subject: | Re: Snorkel hole edging?!?! |
You can get pinchweld and lots of other profiles from Clark Rubber |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|