So I have destroyed a drivers seat mount and not sure what way to go about repairing it, was going to weld a plate on there but its fairly thin, has anybody repaired something like this? Any help is appreciated. Pics below.
| auszookers.com https://auszookers.com/forum/ |
|
| help, damaged seat mount. https://auszookers.com/forum/viewtopic.php?f=5&t=47012 |
Page 1 of 1 |
| Author: | DAZOOK_96 [ Wed Jul 16, 2014 3:09 pm ] |
| Post subject: | help, damaged seat mount. |
So I have destroyed a drivers seat mount and not sure what way to go about repairing it, was going to weld a plate on there but its fairly thin, has anybody repaired something like this? Any help is appreciated. Pics below.
|
|
| Author: | Scrawny [ Wed Jul 16, 2014 6:56 pm ] |
| Post subject: | Re: help, damaged seat mount. |
Could you find another coily body to rob a mount out of? It's just a matter of carefully drilling out the spot welds and tacking the new one in |
|
| Author: | greenzook89 [ Wed Jul 16, 2014 7:26 pm ] |
| Post subject: | Re: help, damaged seat mount. |
I did a similar repair (except mine was rust). I got some 2mm plate and stiched in the new metal, added a captive nut to suit the seat bolt and a bit of paint. Job done. |
|
| Author: | DAZOOK_96 [ Wed Jul 16, 2014 7:34 pm ] |
| Post subject: | Re: help, damaged seat mount. |
Yer I though plating it would be the best/ easiest option. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|