don't buy a dashboard, steering box & a few other LHD specific bits.
| auszookers.com https://www.auszookers.com/forum/ |
|
| samurai calipers on a sierra https://www.auszookers.com/forum/viewtopic.php?f=5&t=47117 |
Page 1 of 1 |
| Author: | sierranoob [ Wed Jul 23, 2014 9:46 pm ] |
| Post subject: | samurai calipers on a sierra |
Just wondering if samurai brake callipers will fit a sierra of the same year. any info would be great thanks |
|
| Author: | shep [ Wed Jul 23, 2014 10:14 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
A samurai is a sierra so yes. If you have to replace sierra calliper have a look fore vitara jobbies as they are bigger |
|
| Author: | sierranoob [ Thu Jul 24, 2014 7:25 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
thankyou very much mate. Is there anything i should watch out for when buying samurai parts for my sierra? |
|
| Author: | atari4x4 [ Thu Jul 24, 2014 7:44 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
don't buy a dashboard, steering box & a few other LHD specific bits.
|
|
| Author: | watermouse [ Thu Jul 24, 2014 8:30 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
atari4x4 wrote: don't buy a dashboard, steering box & a few other LHD specific bits. Unless they are RHD NZ(jap) sammies 
|
|
| Author: | buzbox [ Fri Jul 25, 2014 2:30 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
atari4x4 wrote: don't buy a dashboard, steering box & a few other LHD specific bits. But because we live in the land of down under, LHS become RHS, so it will be fine. Just make sure you put the RHS brake caliper on the LHS. |
|
| Author: | Santos [ Fri Jul 25, 2014 3:26 pm ] |
| Post subject: | Re: samurai calipers on a sierra |
I was under the impression that the stock sierra calipers are symmetrical so you dont need to worry about sides at all... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|