| auszookers.com https://auszookers.com/forum/ |
|
| Wt transfer into Coily https://auszookers.com/forum/viewtopic.php?f=5&t=47416 |
Page 1 of 1 |
| Author: | PurpleZOOK [ Fri Aug 15, 2014 6:01 am ] |
| Post subject: | Wt transfer into Coily |
fitted the eos cradle in no worries but now i've found out the coily flanges are threaded but my leafy case flanges aren't, what do you leafy drivers have fitted just bolts with nylock nuts on the other side? Or should i try and swap the flanges to the old coily ones? |
|
| Author: | coily96 [ Fri Aug 15, 2014 8:51 pm ] |
| Post subject: | Re: Wt transfer into Coily |
viewtopic.php?f=37&t=42645 I had the same issue with mine, used new nuts, bolts and washers. You have to get the correct length bolt aswell. Too long and they will hit the flange and you wont fit a nut on the end. |
|
| Author: | PurpleZOOK [ Sat Aug 16, 2014 2:53 pm ] |
| Post subject: | Re: Wt transfer into Coily |
Thanks mate i did that this morning went out and got my self some nylocks and spring washers as well |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|