Hey man,
If you call up auto barn or repco and ask them for measurements they'll be more then happy to help i recon
| auszookers.com https://auszookers.com/forum/ |
|
| M series Injector dimensions https://auszookers.com/forum/viewtopic.php?f=5&t=47931 |
Page 1 of 1 |
| Author: | royce [ Sat Sep 27, 2014 9:44 am ] |
| Post subject: | M series Injector dimensions |
Anyone with a spare M13 or M18 (or both) injectors able to get some measurements for me? I need overall length, Diameter of both ends where the orings go, maybe some pics of the plug and stuff as well? |
|
| Author: | jimmey [ Sat Sep 27, 2014 11:52 am ] |
| Post subject: | Re: M series Injector dimensions |
Hey man, If you call up auto barn or repco and ask them for measurements they'll be more then happy to help i recon
|
|
| Author: | dougies_tx5turbo [ Sat Sep 27, 2014 12:34 pm ] |
| Post subject: | Re: M series Injector dimensions |
 Hope this helps let me know if you need anything else. I got all new rubber seals at the injector place next door to direct suspension at brendale when I did my m15 swap. Edit that's 7mm inside O ring diameter not the outside. |
|
| Author: | royce [ Sat Sep 27, 2014 12:56 pm ] |
| Post subject: | Re: M series Injector dimensions |
would you say the OD of the top oring is 11mm and the bottom 14mm? |
|
| Author: | royce [ Sat Sep 27, 2014 1:12 pm ] |
| Post subject: | Re: M series Injector dimensions |
and maybe 64mm long centre of oring to center of oring? |
|
| Author: | dougies_tx5turbo [ Sat Sep 27, 2014 1:20 pm ] |
| Post subject: | Re: M series Injector dimensions |
I got 15mm for the bottom and just over 10.5 for the top O ring. I've got 63mm for centre of O rings. I'm not to sure if my vernier gauge is off. Your welcome to come around and have a look if you like, I'm just at brendale. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|