Scrawn wrote:
They're usually a really fine thread with a low profile head.
i made low profile bolts for my RHS bolt in CV, gave them some love with the grinder.
| auszookers.com https://auszookers.com/forum/ |
|
| Bolts for flexplate and torque converter https://auszookers.com/forum/viewtopic.php?f=5&t=47932 |
Page 1 of 1 |
| Author: | Red89 [ Sat Sep 27, 2014 10:02 am ] |
| Post subject: | Bolts for flexplate and torque converter |
Does anyone know where I am likely to pick up the flexplate and torque convertor bolts for the Vit 3sp auto ? Have tried Suzistore but no dice. Can generic bolts be used ? |
|
| Author: | Scrawny [ Sat Sep 27, 2014 11:32 am ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
They're usually a really fine thread with a low profile head. |
|
| Author: | atari4x4 [ Sat Sep 27, 2014 11:52 am ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
Scrawn wrote: They're usually a really fine thread with a low profile head. i made low profile bolts for my RHS bolt in CV, gave them some love with the grinder.
|
|
| Author: | Gwagensteve [ Sat Sep 27, 2014 12:01 pm ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
M10X1.0mm from memory. Don't think flex plate or converter need low profile heads. IIRC flywheels do. Steve. |
|
| Author: | Red89 [ Sat Sep 27, 2014 12:49 pm ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
So they arent shouldered or anything Steve ? I do have bolts in my bolt bucket that fit but have been advised against using random bolts instead of the correct torque converter ones. The engine was a manual and the box never came with them which is why I am looking. |
|
| Author: | Gwagensteve [ Sat Sep 27, 2014 1:53 pm ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
Hmm - might be shouldered. Steve. |
|
| Author: | greyghost [ Sat Sep 27, 2014 3:25 pm ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
there ARE shouldered |
|
| Author: | jdk81 [ Sat Sep 27, 2014 6:04 pm ] |
| Post subject: | Re: Bolts for flexplate and torque converter |
Flexplate bolts are not shouldered. The ones ive seen are the same bolts as flywheel bolts Im pretty sure I saw a container with a set of these yesterday when moving. If you make me an offer worth me going to find them again, ill post them to you. As mitch said, the torque converter bolts are shouldered, and they are a short bolt. just long enough to engage all the thread on the tab. I probably have a set of these kicking around, but unlikely to find them. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|