| auszookers.com https://auszookers.com/forum/ |
|
| g16a into maruti ute https://auszookers.com/forum/viewtopic.php?f=5&t=4813 |
Page 1 of 1 |
| Author: | reallyuted [ Mon May 11, 2009 2:34 am ] |
| Post subject: | g16a into maruti ute |
just need info on the drive shaft from the gear box on a late model 1ltr is the same as the 1.3 or should i get a 1.3 drive shaft just to be sure cheers wayne |
|
| Author: | 11_evl [ Mon May 11, 2009 10:33 am ] |
| Post subject: | Re: g16a into maruti ute |
i have a 1litre jack shaft and it fits into my 1.3 gearbox. i dont no if the 1litre one is early or late but it does fit |
|
| Author: | reallyuted [ Mon May 11, 2009 10:49 pm ] |
| Post subject: | Re: g16a into maruti ute |
cheers mate if it fits it, even if it is the old 1ltr shaft i dont see suzuki changing the later ones! cheers wayne |
|
| Author: | want33s [ Mon May 11, 2009 11:18 pm ] |
| Post subject: | Re: g16a into maruti ute |
Spline is the same where it goes into gearbox but the flange bolt pattern at the other end is different between 1.0/1.3NT and 1.3WT. Jas. |
|
| Author: | reallyuted [ Tue May 12, 2009 2:33 am ] |
| Post subject: | Re: g16a into maruti ute |
just as long as the spline fits the 1.3 box then itll be all good! rumour has it the 1tr wt maruti's have the same flanges as the 1.3 wt |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|