| auszookers.com https://auszookers.com/forum/ |
|
| Belt tensioner Pulley bearing https://auszookers.com/forum/viewtopic.php?f=5&t=48550 |
Page 1 of 1 |
| Author: | Xtreme [ Tue Nov 25, 2014 11:49 am ] |
| Post subject: | Belt tensioner Pulley bearing |
Has anyone replaced the bearing in their tensioner pulley (AC and Power Steering 1999 Jimny)? Mine sounds like the bearing has issues and looking at the cost for a new pulley assembly $149! I wonder if anyone has pressed out the old bearing and pressed in a new one and if so do you remember the bearing you used? |
|
| Author: | droverdave [ Tue Nov 25, 2014 2:19 pm ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
Its more than likely a standard bearing size, so if you measure it and ring up a bearing shop they should be able to supply you with something that will work. Assuming it can be pressed out/in etc. |
|
| Author: | flymaster [ Tue Nov 25, 2014 7:48 pm ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
Done it a few times on Toyota's, bearing cost around $9. Was told that the actual V pulley does suffer from wear in a high klm engine. Nick |
|
| Author: | Xtreme [ Wed Nov 26, 2014 6:18 am ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
Ok thanks, I've taken then pulley off so will go to a bearing shop and see what I can find to suit |
|
| Author: | Xtreme [ Thu Dec 04, 2014 5:04 am ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
Cost for the new bearing was $15 as opposed to $130 for a new pulley and bearing from online. Very simple to tap out the bearing and tap in the new one now is running like a champion again. |
|
| Author: | GraphicX [ Thu Dec 04, 2014 8:58 am ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
i changed the pulley in mine not too long ago, sourced an ebay unit for about $50 so you're in front of me at $15. |
|
| Author: | Xtreme [ Thu Dec 04, 2014 9:19 am ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
That was for the whole pulley Im guessing? the $15 was for the bearing only as I did not need to replace the pulley |
|
| Author: | prolecs [ Sat Dec 23, 2017 1:16 pm ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
Bearing is 80mm OD, 50mm ID and 16mm wide. Sealed both sides. 6010 - (2RS - I think 2RS means it has seals both sides). Ask the bearing shop for best one to suit application |
|
| Author: | prolecs [ Sat Dec 23, 2017 1:17 pm ] |
| Post subject: | Re: Belt tensioner Pulley bearing |
That's for M13A engine |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|