| auszookers.com https://auszookers.com/forum/ |
|
| Sierra Sills https://auszookers.com/forum/viewtopic.php?f=5&t=48756 |
Page 1 of 1 |
| Author: | s.campbell [ Tue Dec 16, 2014 6:28 pm ] |
| Post subject: | Sierra Sills |
Hi I'm in the process of replacing my sierras sills with shs 90x90 I was planning on using 2-3mm thickness Today I contacted just about all the steel suppliers in Adelaide seems 3.5mm is the thinnest I can get. After a lot of research I have found people use different sizes, some use 100x100x3 If I do go the way of the 3.5mm will the weight (about 10kg per sill) be too much for the thin panels it's going to be welded too and will this cause issues?  Thanks for the help in advance Cheers Simon |
|
| Author: | Joshyboy26 [ Tue Dec 16, 2014 6:40 pm ] |
| Post subject: | Re: Sierra Sills |
I used 100x50x4 im pretty sure. It was fine |
|
| Author: | henno [ Tue Dec 16, 2014 7:08 pm ] |
| Post subject: | Re: Sierra Sills |
100x50x4 weighs a lot less than 100x100x3 or 90x90x3.5 |
|
| Author: | jdk81 [ Tue Dec 16, 2014 7:23 pm ] |
| Post subject: | Re: Sierra Sills |
100x100x3 = 8.96 kg/m 89x89x3.5 = 9.07 kg/m 100x50x4 = 8.49 kg/m |
|
| Author: | henno [ Tue Dec 16, 2014 7:32 pm ] |
| Post subject: | Re: Sierra Sills |
I suppose 2kg of extra weight could be seen as not "a lot". I should stop talking in generalities, I suppose. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|