auszookers.com
https://auszookers.com/forum/

M13A Jimny - Power Steering Install
https://auszookers.com/forum/viewtopic.php?f=5&t=48784		 Page 1 of 1
Author:  Hybrid [ Fri Dec 19, 2014 1:11 pm ]
Post subject:  M13A Jimny - Power Steering Install
Hi,

Do I need to cut down the standard AC compressor bracket to fit the PS pump bracket? I can't see any way of doing it. The original AC bracket runs an idler pulley which appears to clash with the PS pump bracket.

Cheers,

John
Author:  Hybrid [ Sat Dec 20, 2014 11:46 am ]
Post subject:  Re: M13A Jimny - Power Steering Install
Ok so I found a picture of this Liana AC bracket (top pic). Comparing it to the bracket from the JX I'm working on (bottom pic) it looks like I can't even cut the existing bracket down. The proper bracket actually lowers the AC pump about an inch to clear the PS pump bracket. It's a bit of a trap for people looking to add PS to their JX Jimny. At least for the early M13a models. Not sure if the later ones come with the right bracket.

Image

Image
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/