i can get a rough pcd off the h25/27 flywheel or off the crank.
will get those h27 int/exh port pics uploaded to.
| auszookers.com https://auszookers.com/forum/ |
|
| h motor, j motor, g motor comparison https://auszookers.com/forum/viewtopic.php?f=5&t=48822 |
Page 1 of 1 |
| Author: | tanshi [ Tue Dec 23, 2014 4:27 pm ] |
| Post subject: | h motor, j motor, g motor comparison |
As most of you know im looking at a h27 for my buggy. to broaden my search a bit I'm trying to figure out what's the same and what's different when it comes to H J and G series motors. What I know already. * G16 and J18 and J20 bell housings are the same pattern and bolt up * G16, J18 and J20 are different to H20 * J series motors have an 8 bolt pattern on the crank where the fly wheel/ flex plate goes. * G series all have a 6 bolt pattern on the crank * J18 fly wheel is the same thickness and diameter as the G16 flywheel. (bigger than a G13 flywheel) * J20 is bigger than the J18 fly wheel. Some points i'd like to find out if I can 1. are the H series cranks the same 8 bolt pattern as the J series 2. do the H series autos use a combined ecu/tcm or are they separate the same as g16 auto tcms. |
|
| Author: | henno [ Tue Dec 23, 2014 6:56 pm ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
1. There are 8 bolts on an H25a/H27a flex plate |
|
| Author: | tanshi [ Tue Dec 23, 2014 7:55 pm ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
Hmm wonder if its the same spacing |
|
| Author: | atari4x4 [ Tue Dec 23, 2014 8:03 pm ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
i can get a rough pcd off the h25/27 flywheel or off the crank. will get those h27 int/exh port pics uploaded to.
|
|
| Author: | tanshi [ Tue Dec 23, 2014 8:23 pm ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
Basically im hoping I can get a manual car or an auto. And just adapt the gearbox I already have |
|
| Author: | fordem [ Wed Dec 24, 2014 12:11 am ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
tanshi wrote: 2. do the H series autos use a combined ecu/tcm or are they separate the same as g16 auto tcms. It may depend on the market the car was built for, but as far as I know, it's a combined PCM (powertrain control module), but, the transmission is the same so you could use the G16 controller once you work out how the two communicate - if I recall correctly there was someone on here building a circuit to do just that.. |
|
| Author: | tanshi [ Wed Dec 24, 2014 7:48 am ] |
| Post subject: | Re: h motor, j motor, g motor comparison |
yeah Jrzook is a mate of mine. He just needs to pull his finger out |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|