Hey all,
Thought I'd share my solution for cabling the roof mount light bar. I battled for a while with the idea of running it down the aerial line, but it seemed a little fiddly and delicate. Rather, I opted to go through the roof rail foot. After popping off the cover (slide forward then up), I drilled a hole through the plastic - just enough the run the cable through.
Then, cringing, I drilled another hole down the foot, and through the roof. Note - a good coat of paint was then sprayed down the hole to prevent rust. Ran the cable through to check the hole was big enough.
Removed the cable, and drilled a hole in the cover of the foot, so the cable could run through. Then, pull it all back together. Done.
I'd like to note as well that my rail feet are cracked already, so I was pretty happy to drill through them. Also, the roof hole was done at my own risk - please have a think about your mounting before following me. Haha.
