| auszookers.com https://auszookers.com/forum/ |
|
| Question on Parts interchangeability and compatability https://auszookers.com/forum/viewtopic.php?f=5&t=49408 |
Page 1 of 1 |
| Author: | Xtreme [ Tue Feb 24, 2015 8:56 am ] |
| Post subject: | Question on Parts interchangeability and compatability |
Hey guys, 1. Does anyone know if a Jimny disc rotor can be mated to a vitara hub assembly? 2. What size rims did the early Vitara come out with (15?) Thanks |
|
| Author: | alien [ Tue Feb 24, 2015 9:06 am ] |
| Post subject: | Re: Question on Parts interchangeability and compatability |
1: Yes - my rear floater conversion runs vitara stubs & hubs and Jimny Rotors. There is a difference in rotors between VVT and non-VVT jimny - the center bore is different (or was it sierra and jimny? not sure) - check my build thread (search "The UFO" and "Floater") for details, i'm sure i posted it. |
|
| Author: | Xtreme [ Tue Feb 24, 2015 9:20 am ] |
| Post subject: | Re: Question on Parts interchangeability and compatability |
Sweet thanks - Exactly what I am doing - will be running vitara stubs and hubs on all corners was not sure if I was meant to keep the Jimny rotors on the front or get vitara ones as well - did you use Pintara Calipers? |
|
| Author: | alien [ Tue Feb 24, 2015 9:36 am ] |
| Post subject: | Re: Question on Parts interchangeability and compatability |
Pintara calipers and swift GTI handbrake cables with a custom botched attachment to the sierra handbrake =) Just really check those bores on the rotors that they're a snug fit.. The other type (jimny / sierra) is 1mm larger from memory - so its held by the studs rather than the hub which isn't ideal... |
|
| Author: | Xtreme [ Tue Feb 24, 2015 9:38 am ] |
| Post subject: | Re: Question on Parts interchangeability and compatability |
ok thanks ill check that out - sweet build on the UFO btw. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|