Hey Guys,
Long story short, I need to pull the woodruff key from my m13 to replace the m18 one. I can't seem to figure anyway of removing it, other than removing the crankshaft... Surely this can't be right can it?
No amount of searching helps. The g series motors are accessible once you take the timing gear off, but m series are chain driven and the only thing that covers the key is the crank pulley. I've tried grabbing it with pliers etc but no luck.
It's also only a $3 part, but I was hoping to use the 1.3 as a learning experience for when I get to the 1.8
Any help would be appreciated
Tim
