auszookers.com
https://auszookers.com/forum/

Help! Input Shaft
https://auszookers.com/forum/viewtopic.php?f=5&t=49843		 Page 1 of 1
Author:  SurfyZook [ Wed Apr 15, 2015 3:35 pm ]
Post subject:  Help! Input Shaft
G'Day Zookers,

I'm overhauling my gearbox and have found a fair bit of wear on the input shaft.

Anyone know where I can find a new one?

I have tried Suzuki but they reckon 4 weeks and $331!

Cheers

SZ
Author:  sideways [ Wed Apr 15, 2015 3:39 pm ]
Post subject:  Re: Help! Input Shaft
For a 1.3l Sierra? Low range sell them. There's 2 different spline types.
Author:  SurfyZook [ Wed Apr 15, 2015 4:27 pm ]
Post subject:  Re: Help! Input Shaft
Its a SJ70

It has a 1.6 vitara engine but the original was a 1.3

Is that low range in the states?

Cheers for the reply Sideways

SZ
Author:  sideways [ Wed Apr 15, 2015 4:49 pm ]
Post subject:  Re: Help! Input Shaft
There you go, back ordered until may though.

http://www.lowrangeoffroad.com/suzuki/s ... parts.html
Author:  SurfyZook [ Wed Apr 15, 2015 5:32 pm ]
Post subject:  Re: Help! Input Shaft
Sideways, you legend!!!

Thanks heaps mate
Author:  mrw82 [ Wed Apr 15, 2015 6:25 pm ]
Post subject:  Re: Help! Input Shaft
If it's just worn where the spigot bearing runs get it machined and sleeved. I done it to mine when I rebuilt it a few years ago and is still all good. If you know someone with a lathe and a press it should cost you no more than a carton, pretty easy job for the right person.
Author:  SurfyZook [ Wed Apr 15, 2015 7:22 pm ]
Post subject:  Re: Help! Input Shaft
Hey Mrw82,

Someone mentioned doing that today when I was doing the ring around

Image

Was yours looking like this?

Image

Also has wearing on the inside

Might be worth checking out, cheers for the heads up
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/