| auszookers.com https://auszookers.com/forum/ |
|
| ARB locker model https://auszookers.com/forum/viewtopic.php?f=5&t=4988 |
Page 1 of 1 |
| Author: | tOngEh [ Thu May 28, 2009 12:52 am ] |
| Post subject: | ARB locker model |
Anyone can advise on which model of ARB locker can be use on the below setup for sierra front axle: 1) 26spl shaft 2) using 413 rear diff with 4 pinion RD88? |
|
| Author: | Zook_Fan [ Thu May 28, 2009 1:26 am ] |
| Post subject: | Re: ARB locker model |
1) so you have the 26 spline side gears? 2) it doesnt matter how many pinion the original carrier is you are swapping it. The ARB locker is a new carrier. If RD88 is for a rear locker for a sierra than that is what you need. |
|
| Author: | joeblow [ Thu May 28, 2009 1:43 am ] |
| Post subject: | Re: ARB locker model |
Zook_Fan wrote: 1) so you have the 26 spline side gears?
2) it doesnt matter how many pinion the original carrier is you are swapping it. The ARB locker is a new carrier. If RD88 is for a rear locker for a sierra than that is what you need. X2....... 
|
|
| Author: | tOngEh [ Thu May 28, 2009 1:50 am ] |
| Post subject: | Re: ARB locker model |
Yes. i do have 26spl side gears. Im not sure if its RD88. Becos the requirement for RD88 is 26splines and 10bolts. I just wanna affirm this. Any zookers here running the same setup? Im sure im not the 1st...Thanks! |
|
| Author: | joeblow [ Thu May 28, 2009 1:57 am ] |
| Post subject: | Re: ARB locker model |
yes, a 1.3 diff is 10 bolt. |
|
| Author: | tOngEh [ Thu May 28, 2009 1:59 am ] |
| Post subject: | Re: ARB locker model |
Thanks alot! Cheers! |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|