Cheers. Will try that if no one else says different. Just didn't want to stuff it up
| auszookers.com https://auszookers.com/forum/ |
|
| Moving brake line clips/brackets to fit sliders https://auszookers.com/forum/viewtopic.php?f=5&t=50163 |
Page 1 of 1 |
| Author: | Twos company [ Sat May 23, 2015 5:25 pm ] |
| Post subject: | Moving brake line clips/brackets to fit sliders |
Probably a stupid question but here goes. On the drivers side chassis my suzuki Sierra has brake lines running along it front to back. These are attached to the chassis at a couple of points with clips which clamp about four parallel lines in them. Just next to the master cylinder I want to take the clip off so I can fit rock sliders with a c clamp on to the chassis then reattach the lines and clip. However I can't work out how to take the clips off. They have a 5mm hole in the middle of the clip and there's something in it but I can't see if it's a tiny socket or what is holding it on the chasis. Any ideas. Cheers |
|
| Author: | Gwagensteve [ Sat May 23, 2015 6:08 pm ] |
| Post subject: | Re: Moving brake line clips/brackets to fit sliders |
I think they just pull off from memory. The bit inside the hole is a sort of threaded stud the clip grips. |
|
| Author: | Twos company [ Sat May 23, 2015 7:39 pm ] |
| Post subject: | Re: Moving brake line clips/brackets to fit sliders |
Cheers. Will try that if no one else says different. Just didn't want to stuff it up
|
|
| Author: | got_bar_work [ Sun May 24, 2015 8:33 pm ] |
| Post subject: | Re: Moving brake line clips/brackets to fit sliders |
I think they are a bolt welded to the chassis The plastic clip pushes on but i dont know if they come back off with out braking |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|