hi fellas, Im about to do the baleno 1.6 coilpack conversion and although ive read a lot if threads (bluezook & cairnszook + others) on this topic i still have some questions....
wiring- took out the donk and now on to removing the wiring, engine wiring is easy enough and i found the ecu, removed the cluster but how far do i go stripping the baleno? under the engine bay fuse box it goes into the front guard, need it?... apart from wires to ecu and cluster do i need anything else? oh and fuel pump.... what about the under dash fuse box above accelerator? is it easier to remove whole dash to get to the wiring?
it already has a 1.6 carb and i can see the gearbox adapter plate, but are these stock or modified mounts? pic below.
will the 1.6 carb extractors fit? if not can i just use the baleno manifold with the sensor and adapt exhaust to fit?
if i do power steering can i use the baleno pump? or need a whole vitara setup?
what it this endless air i have occasionally seen in threads? ( no i havent looked that one up)
i think im good with the vitara or homemade vss, the cooling re routing and tacho replacement so no questions there yet.
anybody fit the baleno seats? i have a sj 80 so its a bit trickier than usual.
is this a sierra or vitara radiator? pic below
if i have a build thread does the car have to have a name? LoL. (actually i dont think it deserves a build thread cause my coily is only doing the engine and a winch bar)
thats all i can think of for now but there will be more im sure. im excited and thanks for all your help..
cheers ken
