auszookers.com
https://auszookers.com/forum/

Carby and Starter Motor Advice
https://auszookers.com/forum/viewtopic.php?f=5&t=50252		 Page 1 of 1
Author:  GreaseMonkey [ Thu Jun 04, 2015 3:08 pm ]
Post subject:  Carby and Starter Motor Advice
Hi Guys,

Im cleaning my carby at the moment as i have been having problems with it problems with it,
I have taken it out of the car and was wondering what would be the best way to clean the whole lot with? (fark all $$$ so cant get carby cleaner)
It is about 2cm thick of greasy dirt all around carby, also is the accelerator pump supposed to shot a continuous stream of fuel? mine sprays the fuel rather than shooting a continuous stream.

Also on my starter motor, are the ends of the pinion gear supposed to be slightly rounded?
Mine look a bit too rounded :?

Thanks,
Author:  ozzycouch [ Thu Jun 04, 2015 8:25 pm ]
Post subject:  Re: Carby and Starter Motor Advice
Petrol and a old tooth brush will get most of it off.
Not to sure about the accelerator jet, see how it is after a clean.
As long as the starter motor is engaging fine, I wouldn't worry about it.
Author:  GreaseMonkey [ Thu Jun 04, 2015 10:30 pm ]
Post subject:  Re: Carby and Starter Motor Advice
Yeah was told to soak the small things in petrol,
Not sure how to take the electrics off (F10a carb) though,

And nah it wasn't engaging, gonna get new one
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/