auszookers.com
https://auszookers.com/forum/

Vibrations in 4x4
https://auszookers.com/forum/viewtopic.php?f=5&t=50410		 Page 1 of 1
Author:  SurfyZook [ Sat Jun 27, 2015 7:49 pm ]
Post subject:  Vibrations in 4x4
Hey Zookers,

I bought my first Zook a couple of months ago

I took it onto the beach the other day for the first time and when I put it in 4x4 it vibrates a heap. Enough to make the temp + fuel gauge shake like crazy and the 4x4 stick to.

This normal?

Cheers

SZ
Author:  J--A--C--K [ Sat Jun 27, 2015 10:02 pm ]
Post subject:  Re: Vibrations in 4x4
Not normal.
Check your uni joints on the front drive shaft.
Author:  Blkfxx [ Sat Jun 27, 2015 10:50 pm ]
Post subject:  Re: Vibrations in 4x4
Also worth checking the front driveshaft slip joint too, Hubs locked in mine and I can't go over 60 it's that bad.
Author:  Scrawny [ Sun Jun 28, 2015 9:47 am ]
Post subject:  Re: Vibrations in 4x4
Is it lifted?
Author:  SurfyZook [ Sun Jun 28, 2015 7:06 pm ]
Post subject:  Re: Vibrations in 4x4
All good!

Checked the drive shaft and the rear one was out 180' on the splines

Still vibrates a bit but no where near as bad as it was. Front uni joint look a bit dodge as well

Cheers fella's

SZ
Author:  SurfyZook [ Sun Jun 28, 2015 7:06 pm ]
Post subject:  Re: Vibrations in 4x4
Yeah it has a 2 inch lift
Author:  Gwagensteve [ Sun Jun 28, 2015 7:23 pm ]
Post subject:  Re: Vibrations in 4x4
Is the front driveshaft in phase?
Author:  flymaster [ Sun Jun 28, 2015 10:22 pm ]
Post subject:  Re: Vibrations in 4x4
They have align dots punched on slip shaft. Mine had wear in the splines, no vibration just awful rattle. Wide Track and Narrow track have different shaft flange bolt spacings and bolt size. Better to have the same brand Uni joints on the shaft.
Author:  SurfyZook [ Sat Jul 04, 2015 11:57 am ]
Post subject:  Re: Vibrations in 4x4
Yeah its in phase

I will check the align dots

Found a set of uni joints on ebay jap made so going to replace those and see how that goes

Thanks again lads
Author:  Scrawny [ Sat Jul 04, 2015 1:36 pm ]
Post subject:  Re: Vibrations in 4x4
Bruce had vibrations in his due to a changed pinion angle. Front uni on the front shaft was running flat while the rear had quite an angle to it
Author:  SurfyZook [ Sun Jul 05, 2015 8:30 am ]
Post subject:  Re: Vibrations in 4x4
Scrawn wrote:
Bruce had vibrations in his due to a changed pinion angle. Front uni on the front shaft was running flat while the rear had quite an angle to it


Cheers mate will have a look at that
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/