| auszookers.com https://auszookers.com/forum/ |
|
| Vitra lock rite into Jimmy rear ? https://auszookers.com/forum/viewtopic.php?f=5&t=50774 |
Page 1 of 1 |
| Author: | chris77 [ Tue Aug 11, 2015 4:59 pm ] |
| Post subject: | Vitra lock rite into Jimmy rear ? |
I have put an early vitara rear lock rite into a 413 rear different but never even seen the insides of a Jimmy diff . A mate has asked if a mid 90's vital rear lock rite would fit a Jimmy rear ? Anyone got any info on this . Thanks Chris |
|
| Author: | AckerDackerly [ Wed Aug 12, 2015 4:28 am ] |
| Post subject: | Re: Vitra lock rite into Jimmy rear ? |
oops. Nothing here to see.... |
|
| Author: | Rhinoman [ Wed Aug 12, 2015 6:24 am ] |
| Post subject: | Re: Vitra lock rite into Jimmy rear ? |
Send an email to Dave Jones at bits4vits in the UK, he has a Vit LSD fitted in a Jimny axle. It was fitted by Rockwatt Engineering. From what I recall from a thread on BigJimny the centre size is the same or similar, Dave or Richard would know for sure. |
|
| Author: | J--A--C--K [ Wed Aug 12, 2015 7:13 am ] |
| Post subject: | Re: Vitra lock rite into Jimmy rear ? |
The easy way would be to look up lockrite and see what they specifi for each car, I'm pretty sure vitara's sierras and Jim's all run the same rear lockers |
|
| Author: | jdk81 [ Wed Aug 12, 2015 12:03 pm ] |
| Post subject: | Re: Vitra lock rite into Jimmy rear ? |
Jack is correct Vits use the same locker pieces, except they retain the factory pins, where the sierra requires new pins, as it has grooves cut into the pins to allow lubrication, but these also act as weak points where cracks occur. It will work, but depends on the pins in the rear of the jimny. If you dont use new pins, it may eventually fail. |
|
| Author: | greyghost [ Wed Aug 12, 2015 2:43 pm ] |
| Post subject: | Re: Vitra lock rite into Jimmy rear ? |
i had a Jimny auto locker in my sierra. it'll fit |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|