| auszookers.com https://auszookers.com/forum/ |
|
| G16b crank angle sensor location https://auszookers.com/forum/viewtopic.php?f=5&t=50865 |
Page 1 of 1 |
| Author: | frak [ Mon Aug 24, 2015 8:25 am ] |
| Post subject: | G16b crank angle sensor location |
So my vit has been okay for a while since the wiring was redone to the battery. Now another problem. Intermittent cant start. It is not fueling based on the tests we ran. Spark is strong. 3rd last time it started ir ran on half cylinders for about 5 seconds before working fine for a 3 hour drive. A mechanic friend of a mechanic friend says it is most likely the cam or crqnk angle sensor based on symptoms. I hav a dizzy so would inly hav the latter afaik. I thought it would b at the front of the sump but nothing there. if womebody knows where it is i would appreciate it. Car is 3 hours away now had to take my parents gv back to work. Thanks Sent from my SM-G900I using Tapatalk |
|
| Author: | Gwagensteve [ Mon Aug 24, 2015 10:06 am ] |
| Post subject: | Re: G16b crank angle sensor location |
No crank angle sensor on a Vitara g16b- camshaft only via the dizzy. |
|
| Author: | fordem [ Mon Aug 24, 2015 1:32 pm ] |
| Post subject: | Re: G16b crank angle sensor location |
If I'm not mistaken there is a "noise filter" that also provides ignition feedback to the ECU, and if that fails, the ECU does not "see the spark" and kills the fueling. http://www.rhinopower.org/diag/cel.html Insert the diagnostic jumper, check for failure codes, crank the engine over with the jumper in place and then without switching the ignition off, check the codes again - it's either a 41 or a 42 |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|