auszookers.com
https://auszookers.com/forum/

Grand vitara 4:3 gearing to 4:8 questions
https://auszookers.com/forum/viewtopic.php?f=5&t=50931		 Page 1 of 1
Author:  2000 gv [ Tue Sep 01, 2015 3:20 pm ]
Post subject:  Grand vitara 4:3 gearing to 4:8 questions
I'm going to be changing my 4:3 gearing to 4:8 gearing and I just wanted to make sure that the 4:8 ring and pinion will bolt straight to the 4:3 centre? Or will I. Need 4:8 centres to fit them? Cheers
Author:  watermouse [ Tue Sep 01, 2015 8:47 pm ]
Post subject:  Re: Grand vitara 4:3 gearing to 4:8 questions
From GV (SQ) and SV The 4.8 ring will bolt to the center from the 4.3. The pinions drop in but the pinion height will need to be checked and shimmed if necessary. Same deal for either end.

The only exception are diffs from the rear of an XL7 as they are physically larger (not sure on ratio so may not be an issue for you. 4.3/5.12? http://www.auszookers.com/forum/viewtopic.php?f=17&t=44910)
Author:  2000 gv [ Wed Sep 02, 2015 9:18 am ]
Post subject:  Re: Grand vitara 4:3 gearing to 4:8 questions
watermouse wrote:
From GV (SQ) and SV The 4.8 ring will bolt to the center from the 4.3. The pinions drop in but the pinion height will need to be checked and shimmed if necessary. Same deal for either end.

The only exception are diffs from the rear of an XL7 as they are physically larger (not sure on ratio so may not be an issue for you. 4.3/5.12? http://www.auszookers.com/forum/viewtopic.php?f=17&t=44910)


So if I was to take my diff and the new gears to a diff shop they would be able to sort that all out for me?
Author:  watermouse [ Wed Sep 02, 2015 12:14 pm ]
Post subject:  Re: Grand vitara 4:3 gearing to 4:8 questions
Yes. A good diff shop will be able to do that for you.

You may want to put a call out for recommended diff workshops in WA that other Auszookers have used.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/