Hey guys having trouble adjusting my choke. I've heard there's 2 lines to match up but can only find one? Is the other supposed to be on the plastic gear itself? There's another line way down near the cam roller but looks to be for something different. It's the standard 2 barrel Aisin carby
The car doesn't run when cold for the first 20 seconds unless you hold the throttle in over 1500rpm. Then I can take my foot off and it runs like a pig (around 700rpm), I then have to turn the hot idle screw in for it to rev by itself around 1500rpm... as it warms up the revs gradually increase until it sits around 2500rpm or over.. thermostat is open and its warm by that point, so I adjust the hot idle screw back down from 2500rpm to about 1100rpm. Then we're ready to go and she runs fine
Go to start it the next morning and she won't run. Hold my foot in turn the screw in let it warm up, then turn it out again once warm rinse and repeat. Any ideas?