| auszookers.com https://auszookers.com/forum/ |
|
| Panhard rods? https://auszookers.com/forum/viewtopic.php?f=5&t=50951 |
Page 1 of 1 |
| Author: | SPEEDY [ Thu Sep 03, 2015 7:52 pm ] |
| Post subject: | Panhard rods? |
How much lift do you need before you need adjustable panhard rods? I was thinking that 40mm lift wouldn't be enough to need it but if I went 80mm then it would. Does that sound right? |
|
| Author: | watermouse [ Thu Sep 03, 2015 8:38 pm ] |
| Post subject: | Re: Panhard rods? |
Depends on how much you value a centered diff housing. My 2inch lifted Jimny pushed the rear end across about 15mm which was noticable and bugged me initially. I put up with it however. |
|
| Author: | Mike57 [ Thu Sep 03, 2015 9:24 pm ] |
| Post subject: | Re: Panhard rods? |
I have a 40mm lift and I would say it is not that bad with this amount. For an 80mm lift I agree you would need some adjustment. I have adjustable rods but these were replaced due to them being stronger. |
|
| Author: | fordem [ Thu Sep 03, 2015 11:12 pm ] |
| Post subject: | Re: Panhard rods? |
Adjustable panhard rods only solve part of the problem - centering the axle - a relocation bracket is a much better solution, it reduces "rear end bump steer" - the sideways movement of the axle as it articulates. |
|
| Author: | got_bar_work [ Fri Sep 04, 2015 6:17 am ] |
| Post subject: | Re: Panhard rods? |
Relocation bracket plus drop pitman arm. If u only do one u will have bump steer |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|