should bolt fit snugly in here. i used the standard bolt, but it is the not the same diamatre as the hole of the mount, or the bush sleeve. do these just tighten up or should the bolt be centreing it aswell.
sam
| auszookers.com https://auszookers.com/forum/ |
|
| panhard rod mount https://auszookers.com/forum/viewtopic.php?f=5&t=5098 |
Page 1 of 1 |
| Author: | Saam [ Mon Jun 08, 2009 2:38 pm ] |
| Post subject: | panhard rod mount |
|
should bolt fit snugly in here. i used the standard bolt, but it is the not the same diamatre as the hole of the mount, or the bush sleeve. do these just tighten up or should the bolt be centreing it aswell. sam |
|
| Author: | want33s [ Mon Jun 08, 2009 2:49 pm ] |
| Post subject: | Re: panhard rod mount |
If the bolt is smaller than the hole it will flog the hole out with movement.. Fit a larger bolt. |
|
| Author: | Saam [ Mon Jun 08, 2009 2:51 pm ] |
| Post subject: | Re: panhard rod mount |
yeah thats what i was thinking, it has been like that for years i had never noticed... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|