aparently you can bore the clynders out 2.8mm over standard.
| auszookers.com https://auszookers.com/forum/ |
|
| g13b bore sizes standard https://auszookers.com/forum/viewtopic.php?f=5&t=5135 |
Page 1 of 1 |
| Author: | skitzlux [ Wed Jun 10, 2009 1:40 am ] |
| Post subject: | g13b bore sizes standard |
im just wondering what the standard bore size is ive honed my block and i wanna know if its been bored out before or if i have to get it bored out thanks guys |
|
| Author: | Damo [ Wed Jun 10, 2009 12:09 pm ] |
| Post subject: | Re: g13b bore sizes standard |
skitzlux wrote: im just wondering what the standard bore size is ive honed my block and i wanna know if its been bored out before or if i have to get it bored out thanks guys
74mm |
|
| Author: | skitzlux [ Thu Jun 11, 2009 12:49 am ] |
| Post subject: | Re: g13b bore sizes standard |
thanks dude |
|
| Author: | Built4thrashing [ Thu Jun 11, 2009 1:47 am ] |
| Post subject: | Re: g13b bore sizes standard |
aparently you can bore the clynders out 2.8mm over standard.
|
|
| Author: | Damo [ Fri Jun 12, 2009 4:29 pm ] |
| Post subject: | Re: g13b bore sizes standard |
Built4thrashing wrote: aparently you can bore the clynders out 2.8mm over standard.
Those cylider walls would be getting mighty thin! Just remember that the G13 block is open deck. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|