| auszookers.com https://auszookers.com/forum/ |
|
| Help Please - 4Wd to 2WD clunking. https://auszookers.com/forum/viewtopic.php?f=5&t=51408 |
Page 1 of 1 |
| Author: | Scott_1988 [ Sun Nov 22, 2015 2:37 pm ] |
| Post subject: | Help Please - 4Wd to 2WD clunking. |
Hi everyone, I just took an 07 Jimny for a test drive and when going from 4wd to 2wd there was a very loud clunking sound from the front. Going from 2wd to 4wd was all fine but going the other way not so good, took me by surprise ! Changed from 2wd to 4wd while stopped, went for drive, pulled over, changed back to 2wd, then started moving and clunk! Is this normal? I am pretty keen on making an offer as the rest of the Jimny was fine but just wanted to make sure I was not buying a lemon first. Thanks, Scott |
|
| Author: | Gwagensteve [ Sun Nov 22, 2015 3:14 pm ] |
| Post subject: | Re: Help Please - 4Wd to 2WD clunking. |
I assume you were only testing the 4WD system on a gravel/dirt road and not on tarmac? Did you carry out any turns whilst checking the 4WD system? Steve. |
|
| Author: | sideways [ Sun Nov 22, 2015 5:42 pm ] |
| Post subject: | Re: Help Please - 4Wd to 2WD clunking. |
They normally go "clink-clink" as the hubs lock or unlock. I've got a manual shift model but I can't recall the VVT one making any other noises. It could go clunk if you had the driveline wound up? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|