| auszookers.com https://auszookers.com/forum/ |
|
| G16 blocks https://auszookers.com/forum/viewtopic.php?f=5&t=51428 |
Page 1 of 1 |
| Author: | SuziBlu [ Wed Nov 25, 2015 9:32 am ] |
| Post subject: | G16 blocks |
Is the two G16 blocks the same, I am led to believe the B series is stronger than the A series, is this true. If I get another G series, would getting B series and putting on the A series goodies be benificial, or not at all, or no match up ? |
|
| Author: | alien [ Wed Nov 25, 2015 4:58 pm ] |
| Post subject: | Re: G16 blocks |
B series have more webbing around the block and are apparently less prone to cracking (apparently). If the A was originally a carby I believe the pistons aren't dished like the 16v ones are. I've had both bottom ends and no issues with cracking. |
|
| Author: | MrRocky [ Wed Nov 25, 2015 9:41 pm ] |
| Post subject: | Re: G16 blocks |
Baleno blocks have a slightly thicker casting Seen alot of vit blocks crack and seep coolant just under the exhaust manifold |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|