| auszookers.com https://auszookers.com/forum/ |
|
| How to close cavity https://auszookers.com/forum/viewtopic.php?f=5&t=51530 |
Page 1 of 1 |
| Author: | kuck [ Fri Dec 11, 2015 8:57 pm ] |
| Post subject: | How to close cavity |
Hi, Have decided to maximise the internal storage capacity of the Jimny 2015 model. Put in 4 inch speakers in the front, and 5.25 inch speakers in the back, then cut the cover to protect the speakers in the back. The plan is to redirect the wires shown in the photo below and then create a 'plug' that closes the big hole. Not sure yet how exactly. Any suggestions welcome. The more pressing question that I have is what I can do to fill the cavity shown in the image below? Appreciate any experience others have had. Thank you. Kuck Distant view https://flic.kr/p/BBN6AY Close up view https://flic.kr/p/C4VpHp |
|
| Author: | 4x4xzook [ Tue Dec 15, 2015 11:17 am ] |
| Post subject: | Re: How to close cavity |
if you look through the "Rigs of Auszookers" Thread section im sure a few people have sectioned that peice off with a peice of timber. |
|
| Author: | pete_79 [ Sun Dec 20, 2015 6:43 am ] |
| Post subject: | How to close cavity |
Wow! The hole in the body will be easy to plug with some MDF board or alloy sheeting. But I don't know what you're going to do with the plastic trimming around the front seat belt. Is there any specific reason why you cut it like that? Probably easiest to totally remove the rest of the panel and make a small box to cover the seat belt retractors. Or get another panel from the wreckers and start again. |
|
| Author: | Qthefun [ Tue Dec 22, 2015 8:16 pm ] |
| Post subject: | Re: How to close cavity |
this: http://www.supercheapauto.com.au/online ... mendations then you can just take out if you need more space. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|